Cuts directly from CAD and DXF
files.
The Model 5555 JetMachining Center cuts complex flat parts out of
most materials including metal, plastic, glass, ceramic, and composites
directly from a CAD drawing or DXF file. No tool changes or complex
fixturing are necessary. Standard features include an X-Y table with
motorized Z-axis; pre-loaded linear bearings and precision ball screws;
complete component protection against water, dirt, and grit; rapid water
level control for submerged cutting; abrasive feed system; direct-drive
pump with 30 hp and 35 hp optional at 50,000 psi and 55,000 psi
respectively; and a patented shear damper. It has a 131" x 95"
x 118" footprint, accuracy of motion at 70[degrees]F, and cuts at
180 ipm. OMAX, Kent, WA
www.rsleads.com/804mn-222
COPYRIGHT 2008 Nelson
Publishing Reproduced with permission of the copyright holder. Further reproduction or distribution is prohibited without permission.
Copyright 2008 Gale, Cengage Learning. All rights
reserved. Gale Group is a Thomson Corporation Company.
NOTE: All illustrations and photos have been removed from this article.