The CHT Thread Inspection System is designed for the in-process
inspection of large diameter parts featuring an extended range of
measurement capability. Available for any UN, UNJ, Buttress, Metric, or
Acme thread greater than 3". All existing pitch diameter or
functional size rolls are interchangeable on the systems. Also being
demonstrated at the show will be the ThreadSpecs 2.0, a fully-integrated
thread engineering software program designed to simplify the calculation
of critical thread elements and characteristics for UN, UNJ, Buttress,
Acme, Metric, Metric J, and Whitworth thread forms. The Johnson Gage
Co., Booth D-4509
[ILLUSTRATION OMITTED]
www.rsleads.com/808mn-200
COPYRIGHT 2008 Nelson
Publishing Reproduced with permission of the copyright holder. Further reproduction or distribution is prohibited without permission.
Copyright 2008 Gale, Cengage Learning. All rights
reserved. Gale Group is a Thomson Corporation Company.
NOTE: All illustrations and photos have been removed from this article.
Copyright ©
Entrepreneur.com, Inc. All rights reserved.
Privacy Policy